Publicité
Main Burners
Read all instructions and warnings before lighting.
1. Make sure there are no obstructions of airflow to gas unit. Spiders and
insects can nest within and clog the burner tube. A clogged burner tube
can lead to a fire beneath appliance.
2. To ignite a burner, push the control knob of the burner in to start
gas flowing.
3. Turn the control knob counterclockwise to activate the starter. If burner
does not light in 5 seconds, turn burner OFF, wait 5 minutes for gas to
clear and repeat procedure.
4. Adjust the temperature to desired level.
After lighting, observe burner flame and make sure all burner ports are lit.
PRE-HEATING NOTE: NEVER PRE-HEAT YOUR GRIDDLE ON HIGH HEAT AS IT CAN CAUSE
DAMAGE TO THE GRIDDLE SURFACE AND NEVER LEAVE YOUR GRIDDLE UNATTENDED
Proper pre-heating will ensure the best cooking performance for your griddle. Always pre-heat your
griddle on the medium or medium-low setting for five minutes and then turn to high heat or desired
temperature level.
If burner flame goes out during operation, immediately turn gas off on control panel and gas cylinder
valve. Open hood and let gas clear for 5 minutes before relighting. Clean grill after each use. DO NOT
use abrasive or flammable cleaners, as they damage parts and may start a fire.
Shutting Off Burners
Turn knob(s) clockwise to HI position, then push in and turn to OFF. Never force knob without pushing
in, as this can damage valve and knob.
Lighting Burner with
a Match
1. Make sure all burner knobs are in OFF position.
2. Remove griddle top.
3. Push in and rotate knob counterclockwise to "HI"
position to start gas flowing.
4. Carefully place lit match near burner ports. Burner
should light immediately.
5. Re-install griddle top
6. Adjust knobs to desired cooking settings.
C-4
Burner Ports
Match
Publicité
