System Settings (Settings) - Cameo OPUS SP5 FC Manuel D'utilisation

SLAVE MODE (Slave)
Select Slave mode as described previously under "STAND-ALONE MODES". Connect the slave and master unit (same model, same software
version) using a DMX cable (Master DMX OUT—Slave DMX IN), and activate one of the stand-alone modes, Auto or Static, on the master
unit. The slave unit will now follow the master unit. Press MODE again to return to the main screen.

SYSTEM SETTINGS (Settings)

Starting from the main display, press ENTER to go to the main menu. Use the UP and DOWN control keys to select the System Settings
menu and press ENTER.
This will take you to the submenu for setting the submenu options, see table (select via UP and DOWN, confirm via ENTER, change status via
UP and DOWN, confirm via ENTER):
Settings (bold = factory setting)
Display Display settings
DMX Fail Operating status if DMX
signal is lost
Dimmer Curve Select the
dimmer curve
Reverse OFF
ON
Backlight OFF
ON
Black
Hold
Auto
Linear
Exponential
Logarithmic
S-curve
Display does not rotate
Display rotates by 180° (when installed overhead)
Deactivates display backlight after approx. 30
seconds of inactivity
Display backlight permanently on
Activates Blackout
Last command is held
Activates auto mode
The light intensity climbs linearly with the DMX value
The light intensity can be set finely in the lower
DMX value range and roughly in the upper DMX
value range
The light intensity can be set roughly in the lower
DMX value range and finely in the upper DMX value
range
The light intensity can be set finely in the lower and
upper DMX value ranges and roughly in the medium
DMX value range
11