Adjusting The Dmx Start Address; System Settings - Cameo TWINSCAN 20 Manuel D'utilisation

OPERATION / BEDIENUNG / UTILISATION / OPERACIÓN / OBSŁUGA / UTILIZZO
EN
A few seconds after connecting to the power supply, the effects projector is ready for operation and the operating mode that was previously
selected is activated.
ADJUSTING THE OPERATING MODE
Press the MODE button repeatedly until "MOde" appears on the display and save the entry by pressing ENTER. Using the UP and DOWN buttons,
select the desired operating mode and confirm with ENTER.
DMX modes 1-channel, 3-channel, 4-channel, 8-channel (You will find tables with the channels of the different DMX modes on the following
pages of this user's manual):
SLAVE mode
Once the slave unit has been connected to the master unit (same model) using a DMX cable (Master = DMX OUT, Slave = DMX IN), and the master
unit has been set to one of the standalone modes (automatic control or music control), the slave unit follows the master unit.
AUTO mode
Once you have selected the AUTO mode and confirmed the selection by pressing ENTER, the automatic program currently enabled will show on the
display (AUt1 - AUt9). Press ENTER again and select one of the 9 different programs (digits flash, select using the UP and DOWN buttons and confirm
with ENTER). To adjust the running speed of the activated program (SP00 - SP99), press once on UP or DOWN, then on ENTER and select the speed
using the UP and DOWN buttons (SP00 = minimum speed, SP99 = maximum speed). Confirm with ENTER.
Music control mode
Once you have selected the Music control mode and confirmed the selection by pressing ENTER, the program currently enabled will show on the dis-
play (SOU1 - SOU9). Press ENTER again and select one of the 9 different programs (digits flash, select using the UP and DOWN buttons and confirm
with ENTER). To adjust the microphone sensitivity (Se00 - Se99), press once on UP or DOWN, then on ENTER and select the sensitivity using the UP
and DOWN buttons (Se00 = minimum sensitivity, Se99 = maximum sensitivity). Confirm with ENTER.

ADJUSTING THE DMX START ADDRESS

Press the MODE button repeatedly until "Addr" appears on the display and confirm by pressing ENTER. While the characters are flashing on the
display, the DMX start address can be set as desired using the UP and DOWN buttons (A001 - A512). To confirm, press ENTER. The synchronous
control of multiple lasers (same model) through a DMX control unit (e.g. DMX mixer) can be achieved by assigning the spotlights to an identical DMX
start address and connecting them using DMX cables.

SYSTEM SETTINGS

To adjust the system settings, reset settings, initialise the engine and query system data, press the MODE button repeatedly until "Sett" appears on
the display and confirm by pressing ENTER. Using the UP and DOWN buttons, select the desired menu items in the system settings and confirm with
ENTER.
The menu items and their functions are shown in the table below:
14