Slave Mode; System Settings (Settings) - Cameo UVO Manuel D'utilisation

STATIC COLOURS MODE
In the static colours mode, each of the PAR lamps' 4-colour LEDs can be individually adjusted for brightness, and an additional strobe effect
can be activated. Press the MODE button repeatedly until one of the main menu items is displayed (Addr, ModE, SEt, inFo). Using the UP and
DOWN buttons, select the menu item "ModE" and confirm with ENTER and then select "Auto" (display LED "coLo" will light up). Now the
brightness of the red LED can be set as required between r 00 to r 99, using the UP and DOWN buttons. Confirm again with ENTER. After
selecting the brightness value for the green (g 00 - g 99), blue (b 00 - b 99), and UV LED (u 00 - u 99) in the same way, the strobe-effect can
now be activated (St00 = strobe effect disabled, St01 = slowest flash speed, St99 = fastest flash speed). Confirm your entry with ENTER.
-> ENTER ->
<- MODE
UP/DOWN

SLAVE MODE

Press the MODE button repeatedly until one of the main menu items is displayed (Addr, ModE, SEt, inFo). Using the UP and DOWN buttons,
select the menu item "ModE" and confirm with ENTER and then select "SLAV". Confirm with ENTER (display LED "SLAVE" will light up).
Connect the slave and the master unit (same model) with a DMX cable (Master = DMX OUT, Slave = DMX IN) and enable one of the standalone
modes on the master unit (automatic-control, sound-control or static colours). Now the slave unit will follow the master unit. If there is no
control signal, the display characters will flash. Flashing stops as soon as a control signal is present.

SYSTEM SETTINGS (SETTINGS)

In the System menu, display-shutdown, display-rotation by 180° and operation in the event of signal interruption can be configured, as well
as a reset to factory settings. Press the MODE button repeatedly until one of the main menu items is displayed (Addr, ModE, SEt, inFo). Using
the UP and DOWN buttons, select the menu item "SEt" and confirm with ENTER and then select the desired menu item using the UP and
DOWN buttons. Confirm with ENTER and adjust the settings as required suing the UP and DOWN buttons. Confirm your entry with ENTER.
-> ENTER ->
INFO (SOFTWARE VERSION)
Press the MODE button repeatedly until one of the main menu items is displayed (Addr, ModE, SEt, inFo).
To show the device software version, use the UP and DOWN buttons to select the menu item "inFo", then press ENTER twice.
-> ENTER ->
10
-> ENTER -> -> ENTER ->
<- MODE <- MODE
UP/DOWN
-> ENTER ->
UP/DOWN
<- MODE
Display
Shutdown
/
-> ENTER ->
UP/DOWN
<- MODE
Display rotation
180°
/
-> ENTER ->
UP/DOWN
<- MODE
In the event of
interruption of DMX signal
/
-> ENTER ->
UP/DOWN
<- MODE
Restore
factory setting
-> ENTER ->
-> ENTER ->
<- MODE
UP/DOWN UP/DOWN
/
UP/DOWN
Display Display shut down
on permanently after approx. 70 seconds
/
UP/DOWN
No rotation 180°rotation
/
UP/DOWN
or blackout, the last DMX command
is retained.
/
UP/DOWN
Restore Do not restore
-> ENTER -> -> ENTER
<- MODE <- MODE
UP/DOWN
-> ENTER
<- MODE
-> ENTER
<- MODE
-> ENTER
<- MODE
-> ENTER
<- MODE