Publicité
Les langues disponibles
Les langues disponibles
EN
Connecting the fixture to 12 V
The already installed lamp means the fixture is immediately ready for
use. Therefore you do not need to install the lamp first.
Caution! This fixture is water tight under pressure to a depth of 3
meters (IP-68). Always position the mini-connector out of the water.
Step 1
Remove the wing screw from the toothed coupling of the housing.
Attach the base to the lamp by placing the two toothed coupling
halves on top of one another. Place the cable in the recess intended
for this purpose. Stick the wing screw through the hole in the base and
tighten it. Decide how you want your lamp to be positioned before you
tighten the wing screw fully. (Fig. 1)
Step 2
For extra weighting under water, fix the four small weights into the
base (Fig. 1)
Step 3
Join the Easy-Lock connector to the main cable. (Fig. 2)
a. Clamp the cable duct on top of the main cable.
b. Place the cable duct (with the cable at the bottom) in the Easy-
Lock connector.
c. Tighten the threaded cap on the Easy-Lock connector. This will
cause the contacts to be pushed through the insulation on the
cable. In tightening the cap, a little gel is applied to the contacts in
the Easy-Lock connector. This serves to protect the contacts
against moisture. A little gel may possibly come out of the Easy-
Lock connector: so after installation (and/or before a meal), wash
your hands with soap and water, and avoid the gel coming into
contact with your eyes.
Step 4
Connect the main cable to the fixture by connecting the mini-
connector. (Fig. 3)
Caution! Always position the mini-connector out of the water.
If the lamp does not work correctly, check that the Easy-Lock connec-
tor is properly connected to the main cable. Do the same for the mini-
connector. Repeat steps 3 and 4. When the fixture is connected to the
main cable also check that the contacts of the Easy-Lock connector
are not bent. If you have any problems, contact your dealer.
General maintenance advice
We advise wiping the fixture down at least once a year using a clean
cloth and warm water.
Publicité
