Publicité
Generally
This appliance is for private use only and must not be used commercially. Please read
the instruction manual carefully and keep it at a safe place. When the appliance is
given to another person the instruction manual should be passed to that person, too.
Only use the appliance as described in the instruction manual and pay attention to
the safety information. No liability for damages or accidents will be accepted, which
are caused by not paying attention to the instruction manual.
Safety information:
∙
Connect and operate the appliance only in accordance with the specifications on
the rating label.
∙
Do not use if the power cord is damaged. This must be checked before each use.
∙
This appliance is not intended for use by persons (including children)
with reduced physical, sensory, or mental capacities, or lack of experience
and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety
∙
Children should be supervised to ensure that they do not play with the appliance.
∙
The appliance is not intended to be operated by means of an external timer or
separate remote control system.
∙
After each use or in the case of a malfunction the plug must be pulled out of the
socket.
∙
Never pull at the power cord. Do not chafe it over sharp edges or squeeze it.
∙
Attention!
Some parts of this product can become very hot and cause burns. Parti-
cular attention has to be given where children and vulnerable people are present.
∙
Make sure that your supply rating corresponds to what specified on the rating
plate: 230V~, 50Hz.
∙
This unit has an IP21 protection level and is suitable for use in bathroom. Do not
use this heater in the immediate surroundings of a bath, a shower or a swimming
pool.
∙
In environment of a wash basin, socket outlets are permitted only if they are pro-
tected by a residual current protective device with a residual operating current/Om
not exceeding 30mA.
∙
Don't leave your home while the appliance is in function: ensure in this case that
the switch is in OFF (0) position and the thermostat is in minimum position (*).
∙
During function, place the heater in a safe position:
∙
at least 1m far from inflammable objects or furnitures;
∙
leaving not less than 1m of free space in front of the heater;
∙
not located immediately below a socket-outlet.
∙
Do not leave animals or children touch or play with the appliance. Pay attention!
The air outlet grille gets hot during operation (more than 90°C)
∙
WARNING: In order to avoid overheating, do not cover the heater.
Do not hang anything on the heater and do not cover it while it's wor-
king. This is clearly written on the cover of the product or shown by the
symbol.
∙
Do not use the heater in rooms with explosive gas or while using inflammable
solvents or varnish or glues.
8
∙
If the cordset is damaged and you have to change it, do not do the job yourselves!
Take the product to an after sales authorised repair centre or to a person with simi-
lar skill and knowledge, in order to avoid any risk of danger.
∙
The appliance must be positioned so that the plug is always accessible.
∙
This heater is fitted with a double electrical insulation circuit (class II) and therefore
does not require an earth connection.
∙
It must never be possible for people in the bath tub or shower to reach the adjust-
ment knobs.
∙
This heater must be correctly installed in compliance with the regulations in force in
the country of installation.
Using the fan heater
∙
The heater is fitted with a switch and an ambient thermostat .
∙
The switch is used to control heater's functioning selecting the off condition, cold
air ventilation, warm air (1000W) or hot air (2000W).
Using the thermostat
∙
In a room with a temperature exceeding 30°C, the thermostat does not turn on the
fan heater even if it is at maximum.
∙
Vice-versa, in a room with a very low temperature (below 5°C), it is normal that the
thermostat keeps the heater constantly on, even if it is at minimum.
∙
To optimise use of the thermostat, proceed as follows:
∙
turn the thermostat knob to maximum and wait until a comfortable temperature is
reached;
∙
then turn the thermostat knob anti-clockwise until you hear a "click" and the hea-
ter turns off;
∙
turn the thermostat knob clockwise just a little;
∙
in this position, the thermostat will maintain the selected ambient temperature.
Troubleshooting
∙
In the event of overheating, the safety device on the appliance automatically disa-
bled the heating elements and motor. As a result, the heater stops working . In this
case:
∙
Turn off the fan heater and allow it to cool down for about 15/20 minutes.
∙
Eliminate any other possible reasons for overheating (e.g.: obstructions in front of
the air inlet/outlet grilles, build-ups of dirt).
∙
Turn on the fan heater again and check it works correctly.
Maintenance
∙
This product does not require any special maintenance.
∙
Clean the product with a dry cloth once every 6 months.
∙
If the product requires repairing, contact an authorised technical service centre.
∙
When replacing the power cable, use a 2x0,75mm2 H05VV-F HAR type. This opera-
tion must be performed by qualified personnel and never by the end user in order
to avoid damaging the appliance and jeopardising personal safety.
9
Publicité
