Publicité
•
Remove the hole cover in the opposite upper position by hand or with a
thin screwdriver
•
Apply the upper hinge in the opposite position, matching the holes with
those on the casing
•
Apply the hatch from below after turning it upside down, matching the
hole with the hinge pin
•
Apply the lower hinge in the new position, matching the holes with those
on the casing (it may be necessary to drill the white insulation)
•
Apply the front screw foot in the corresponding hole opposite the lower
hinge
•
Tighten the screws fully and check that the seal is properly sealed
5. USE OF THE EQUIPMENT
Use the refrigerator for storing and cooling food, considering the following
indications:
•
The product may offer reduced performance in particularly high ambient
temperatures
•
Opening the door worsens the refrigeration performance, proportionally
to the number of openings and how close they are over time
•
Energy consumption is proportional to the amount of refrigeration
required: it increases in all cases where it is required to reach a particularly
low temperature, where a particularly large quantity of food is stored or
where the door is frequently opened
•
Always keep in mind, even during continuous use, what was previously
explained in chap. 2
6. CARE AND MAINTENANCE
The product does not require maintenance.
For cleaning, use a damp cloth, ignoring aggressive or abrasive detergents. In case of
encrustations or greasy material, use a small amount of common dish soap and rinse
thoroughly.
The cleaning operations must be carried out with the appliance switched off and the
cable disconnected; wait for it to dry completely before reconnecting the cable to
the socket.
Periodically it may be useful to check for accumulations of dust on the perimeter
ventilation slots: if there is dust, disconnect the power cable, remove the dust with
a brush with long, soft bristles, then reconnect the power supply.
Never use a vacuum cleaner to remove accumulations of dust from the fan.
Publicité
