Publicité
3. PARTS IDENTIFICATION
1. Cabinet | 2. Shelf | 3. Foot | 4. Door gasket | 5. Door | 6. Low hinge
4. START THE PRODUCT
1)
Remove the product from the packaging
2)
Place it in the correct position on a flat and stable surface, a short distance
from an electrical socket and protected from direct solar radiation
3)
Ensure there is at least 20cm of clearance from surrounding surfaces in all
directions
4)
Ensure an uninterrupted path of the air from below to the top passing
through the rear part: only the effective expulsion of the heated air
guarantees the expected performance, therefore it is necessary to ensure
the formation of an air current by exploiting the " chimney principle" as
described in the figure:
Publicité
