Publicité
EN
B
House creation
See house creation section.
C
Radio pairing
See radio pairing section.
D
Delete a device
Select device type and then the
device.
E
Delete all devices
All devices installed in the system will
be deleted (rooms will be maintained).
F
Antifreeze setpoint
You can set the antifreeze setpoint as
reference for the whole installation.
G
Heating setting
You can fix setpoint limitations (min/
max) per zone and the offset assigned
to devices working in floor sensor reg-
ulation.
H
Heating/cooling settings
You can set the installation in heating
mode, in cooling mode or in manual
mode. If you set the device in manual
mode, the
main menu
I
General factory default
To reset the system with the factory val-
ues, but the software version will remain
the same.
J
Update Firmware
To update the software, with the SD-card.
The system is qualified to work with
SD-cards less than or equal to 16GB.
Select
to proceed (long press)
Please wait the end of the update
procedure (The Wifi icon should be
available for the Wifi central unit) before
removing the microSD from the cen-
tral unit. The SW and the procedure to
update the central unit is available on
www.wattswater.eu.
BT-CT03-RF-IOM-FR-W-EN-10-23
icon appears on the
3.2 User settings
Adjust time/date
Date and time can be set manually or
automatically.
If auto is selected, location must be defined
on the smartphone or web application.
Then, the device will automatically get cur-
rent time from internet (Wi-Fi connection is
mandatory).
Language
Language settings - see MAIN MENU
section.
Personalization
Personalization settings (background color,
screen brightness, etc). See "User Settings
Menu" in MAIN MENU section for further
information.
3.3 Configure your house
Now, you need to "create" your house - a
list of rooms where various devices such
as thermostats will be placed.
Create all the rooms and re-name them
(e.g. Room 1 = Kitchen, Room 2 =
Lounge, etc)
9
Publicité
