Monacor International IMG Stage Line PAK-110MK2 Mode D'emploi page 9

6) Adjust the sound as desired with the two controls
TREBLE (11) and BASS (12).
7) With the control MASTER LEVEL (10), adjust the
desired overall volume. Only turn up the control to
such an extent that the sound reproduced will not
be distorted. If the overload LED CLIP (13) lights
up, turn back the control accordingly. Then readjust
the sound, if required.
8) After use, switch off the speaker system with the
POWER switch.
6 Specifications
Model
Amplifier power
RMS power
Peak power
Frequency range
Max. rated SPL
Bass speaker
Tweeter
Input sensitivity
MIC IN, XLR jack and 6.3 mm jack
LINE IN, XLR jack
LINE IN, phono jacks
Output LINE OUT, XLR jack
and 6.3 mm jack
Ambient temperature
Power supply
Power consumption max.
Dimensions (W × H × D)
Weight
Pin configuration of XLR jacks:
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
PAK-110MK2
110 W
200 W
59 – 20 000 Hz
116 dB
25 cm (10")
230 V~/ 50 Hz
300 VA
360 × 500 × 260 mm
12.9 kg
1 = ground
2 = signal +
3 = signal -
® INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
PAK-112MK2
150 W
270 W
49 – 20 000 Hz
118 dB
30 cm (12")
dynamic horn tweeter, 2.54 cm (1")
6.5 mV
150 mV
620 mV
200 mV
0 – 40 °C
230 V~/ 50 Hz
340 VA
430 × 580 × 310 mm
20 kg
Subject to technical modification.
PAK-115MK2
175 W
300 W
45 – 20 000 Hz
119 dB
38 cm (15")
10 mV
240 mV
950 mV
230 V~/ 50 Hz
370 VA
447 × 685 × 355 mm
22.8 kg
T = signal +
R = signal -
S = ground
9