Publicité
How to Use
This appliance is for household use only.
GETTING STARTED
•
Remove all packing materials, any stickers and the plastic band around the power plug.
•
To register your product, go to www.prodprotect.com/russellhobbs.
•
Wash all parts as instructed in CARE and MAINTENANCE section.
•
Select a level surface where this unit is to be used allowing enough space for
steam to escape without damage to counters, cabinets and walls.
PARTS
1.
Lid
2.
Water reservoir
3.
Removable filter
(part no. CM3100-01)
4.
Filter holder (part no. CM3100-02)
5.
Water gauge
BEFORE USING FOR THE FIRST TIME
Fill the reservoir to the max mark, and run the appliance without coffee.
•
•
Let it cool, discard the water, then use it normally.
FILLING
1.
Remove the carafe from the hotplate.
2.
Open the lid.
Fill with at least 2 cups of water, but not above the max mark.
3.
4.
Place the removable filter or a paper filter (not included) into the filter holder.
5.
Put 1 scoop of filter-ground coffee into the filter for each cup.
6.
Close the lid.
7.
Replace the carafe on the hotplate.
MAKING COFFEE
CAUTION: DO NOT open the lid during brewing as there is the potential risk of scalding.
1.
Put the plug into the power socket.
2.
Move the switch to I. The light will come on.
3.
Shortly afterwards, coffee will start to drip into the carafe.
4.
When it's done, the hotplate will keep the carafe warm. After 40 minutes, the
hotplate and appliance will shut down.
Move the switch to O to turn off.
5.
6.
Unplug, and let the appliance and carafe cool down fully before cleaning, or for
about 10 minutes before refilling.
7.
For the best flavour, drink the coffee within 40 minutes of brewing.
6.
Hot plate
7.
On/off switch
8.
1.25L carafe (part no. CM3100-03)
9.
Coffee brewing progress gauge
10. 1-cup coffee scoop
(part no. CM3100-04)
5
Publicité
