Whirlpool W11241780A Instructions Pour L'installation page 15

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2. Unscrew the regulator cap, and then remove the plastic
cover.
A. Plastic cover
B. Regulator cap
3. Flip the regulator pin over, and then replace the plastic cover.
A
A. Natural gas position
B. Propane gas position
C. Plastic cover
4. Screw the regulator cap securely back into place. Do not
overtighten.
To Convert Surface Burners
1. If the burner grates are installed, remove them.
2. Remove the burner caps.
3. Using a Phillips or T20
®
base.
A
B
A. Burner cap
B. Gas tube opening
TORX and T20 are registered trademarks of Acument Intellectual Properties, LLC.
®
A
B
B
C
Torx
screwdriver, remove the burner
®
C
D
C. Burner base screws
D. Burner base
4. Apply masking tape to the end of a 9/32" (7.0 mm) nut driver
to help hold the Natural gas orifice spud in the nut driver
while changing it. Press nut driver down onto the Natural gas
orifice spud and remove by turning it counterclockwise and
lifting out. Set the Natural gas orifice spud aside.
A. Natural gas orifice spud
Use the following chart for correct propane gas orifice spud for
each burner. Refer to the model/serial/rating plate behind the
control panel for proper sizing of propane gas orifice spuds for
each burner location.
Propane Gas Orifice Spud Chart
Burner Rating
Color
4,000 BTU
Blue
7,000 BTU
Black
9,100 BTU
Green
14,000 BTU
Red
5. Replace the Natural gas orifice spud with the correct
propane gas orifice spud. See the "Propane Gas Orifice
Spud Chart".
6. Replace burner base and hand tighten the screws.
7. Replace burner cap.
8. Repeat steps 1 through 7 for the remaining burners.
9. Place Natural gas orifice spuds in plastic parts bag for future
use and keep with literature package.
10. Replace burner grates.
11. Complete installation. See "Make Gas Connection" and
Electronic Ignition System" sections.
Checking for proper cooktop burner flame is very important.
The small inner cone should have a very distinct blue flame
1/4" to 1/2" (0.64 to 1.3 cm) long. The outer cone is not as
distinct as the inner cone. Propane gas flames have a slightly
yellow tip.
IMPORTANT: You may have to adjust the low setting for
each cooktop burner.
A
Number
64L
81L
97L
114L
15

Publicité

Table des Matières
loading

Table des Matières