Publicité
liquid receptacles (e.g. sinks, etc.) to avoid water splashing onto the appliance or it
-
falling in (minimum distance of 2 meters)
fabrics (curtains, etc.) or floating materials that could obstruct the air intake grille;
-
make sure that the front is free of floating materials (dust, etc.).
• The appliance must not be used in dusty environments or in the presence of floating
materials or used in a room where there is a fire risk.
• The appliance must not be used in dusty environments or in the presence of floating materials or used
in a room where there is a fire risk.
ASSEMBLY
Attention: the fan can be used only when completely and correctly assembled, that is complete
with protection grids (rear and front). If in doubt, have the appliance checked or assembled by a
qualified professional person.
Attention: always unplug the appliance before you assemble the appliance.
Wall installation
• The appliance must only be used if secured to a wall: the wall must be flat, smooth, very stable (as
the appliance could tip over) and resistant.
• To install the appliance, proceed as follows and refer to the figures:
check that the wall must be made of masonry and/ or of resistant material (not of wood or
-
synthetic material)
ensure that the wall/structure to which the fan will be fixed can support a weight of 15kg
-
the wall fan must be installed at least 2 m above the floor,
-
clearance to the side of the fan
Mounting Bracket
the
-
the two motor support rings must be vertical), in perfect adherence to the surface
before drilling into the ceiling, make sure that you do will damage any internal ductwork
-
using the Mounting Bracket (1) as a guide, mark the points where will be drilled the 4
-
holes
remove the Mounting Bracket, drill the 4 holes (diam, 8mm), and insert 4 expansion plugs:
-
use the nuts and insert the flat and elastic washers for fixing. The nuts must be tightened
fully and the plate securely fastened to prevent the fan from oscillating
insert the support (2) inside the two rings of the bracket (unscrew the screws if previously
-
screwed), so that the two holes (support and lower ring) are coaxial and insert the appropriate
screw (M8x45) (3A) , then insert the other screw (M8x16) (3B). The screws must be tightened
fully.
Ventilator
1)
Remove the engine support/motor screw (4) and the clutch screw (tilt up/down) (5). Position the
motor body (6) on the support (2), insert the support screw (4) inside its seat, the head of the
screw (must be in the part with the writing: inside the recess of the support, place the washer
and screw the nut properly. Insert the clutch screw (5) to lock the motor body in the desired
position.
2)
Fix the control box (14) to the support using the screw supplied (M6x55).
must be fixed horizontally (so that the long side must be at the top and
14/28
and that there is at least 1m
Publicité
