Publicité
• Do not, under any circumstances, cut or remove the third ground prong from the power
cord supplied.
• This refrigerator requires a standard 115 Volt A.C. ~/60Hz electrical outlet with three-prong
ground.
• This refrigerator is not designed to be used with an inverter.
• The cord should be secured behind the refrigerator and not left exposed or dangling to
prevent accidental injury.
• Never unplug the refrigerator by pulling the power cord. Always grip the plug firmly and pull
straight out from the receptacle.
• Do not use an extension cord with this appliance. If the power cord is too short, have a
qualified electrician or service technician install an outlet near the appliance. Use of an
extension cord can negatively affect the performance of the unit.
REVERSING THE DOOR HINGE
1. Remove the top hinge cover.
2. Using a Phillips screwdriver, loosen and remove the screws holding the top hinge in
place.
3. Remove top hinge and carefully lift off the door.
4. Remove the screw hole plugs from the opposite side and insert the plugs in the screw
hole openings of the just removed screws.
5. Remove any loose items in the refrigerator and carefully turn refrigerator on its back,
remove both leveling legs and place in a secure area.
6. Loosen the screws holding the lower hinge bracket to the refrigerator and remove screws
and bracket.
7. Remove (2) screws from the other side and insert in the previously removed screw holes.
8. Remove door pin by turning counterclockwise and reinsert to the underside of the bracket
and tighten.
9. Align bracket and insert (2) remaining screws into the holes provided.
10. Align hole in the door with the door pin and washer and gently push down until firm.
11. Align upper hinge bracket with screw holes insert screws and partially secure, check that
door and cabinet are properly aligned and then secure tightly.
12. Replace hinge cap.
-6-
Publicité
