LG DLGX2902V Guide De L'utilisateur Et Directives D'installation page 30

OPERATING THE DRYER
Once you have loaded the dryer:
Press the ON/OFF button to turn on the
1
dryer. The lights around the cycle
selector knob will illuminate.
Turn the cycle selector knob to the desired
2
cycle. The display will show
the preset Dry Level,
Temperature, Time, and
Option settings for that cycle.
3 If you would like to change the settings
for that cycle, such as the dry level or
temperature, press the appropriate cycle
settings button(s) until the indicator light for
the desired setting is lit.
NOTE: To protect your garments, not every
dry level, temperature, or option is available
with every cycle.
Select any additional cycle options, such
4
as WRINKLE CARE, ANTI BACTERIAL, or
DAMP DRY BEEP, by pressing the button
for that option. The indicator light on the
button will light to show that option has been
selected. To deselect an option, press the
button again.
NOTE: To protect your garments, not every
dry level, temperature, or option is available
with every cycle.
Press the START/PAUSE button to begin the
5
cycle. The display will change,
and the dryer will display the
estimated (SENSOR DRY) or set
time (MANUAL DRY) remaining
and start tumbling. To pause the cycle at any
time, for example to clean the lint filter or to
remove a garment, open the dryer door or
press PAUSE. To resume the cycle where it
was stopped, press START/PAUSE again.
NOTE: If the dryer has been stopped for
more than 8 minutes, the dryer will turn
off automatically.
When the load is finished, the beeper (if
6
set) will sound. If you have set the Wrinkle
Care option, the dryer will tumble the load
periodically for up to 3 hours.
To prevent wrinkling, remove items from the
dryer immediately after the end of the cycle.
Always clean the lint filter after every cycle.
7
To clean, pull the lint filter straight up and
roll any lint off the filter with your fingers.
Do not rinse or wash the filter to remove lint.
Push the lint filter firmly back into place.
29