Publicité
Step 24
1
RIGHT DRAWER
SIDE with logo.
D636
Groove
å
Insert one set of DRAWER SIDES (D635 and D636)
at an angle into the slot at each end of one LEFT
DRAWER FRONT (M).
3
M67
1
M67
Surface with
HIDDEN CAM
å
Push one HIDDEN CAM (1F) into a DRAWER
BRACE (M67). Then, insert the metal end of a CAM
DOWEL (2F) into the HIDDEN CAM.
å
Fasten the DRAWER BRACE (M67) to the LEFT
DRAWER FRONT (M). Tighten one HIDDEN CAM.
420946
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
LEFT DRAWER
SIDE with label.
D635
M
Arrow
Metal end
1F
2F
Hidden part using
recycled material.
Color may vary.
M
www.sauder.com/service
2
U n fi
n i s h
D636
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide a DRAWER BOTTOM (D985) into the grooves
in the DRAWER SIDES (D635 and D636) and LEFT
DRAWER FRONT (M).
4
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D80
D636
M67
å
Fasten a DRAWER BACK (D80) to the DRAWER
SIDES (D635 and D636) and DRAWER BRACE (M67).
Use five BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
Repeat this step for the remaining drawers.
1
9
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
D985
e d
s u r
f a c
e
D635
M
30S
(30 used in this step)
Be sure the
D635
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Page 29
Publicité
