Publicité
Step 23
å
Carefully stand your unit upright in its final location. We recommend using the SAFETY STRAP for added stability.
STUD INSTALLATION
1. Locate the center of a stud in your wall near your unit
and mark it with a pencil just below the top surface of
your unit so the SAFETY STRAP will not be visible.
2. Drill a 1/8" hole on the mark and into the stud in
your wall.
3. Fasten the unit to the wall. Use the LONG SCREW
from the FURNITURE TIPPING RESTRAINT KIT (96)
through the hole in the SAFETY STRAP and into
the 1/8" hole.
Electric drill
with 1/8" bit
2
3
STUD INSTALLATION
Page 28
Mark and drill
a 1/8" hole
into the wall.
1
96
www.sauder.com/service
WALL ANCHOR INSTALLATION
1. Use a pencil to mark your wall in your desired location just
below the top surface of your unit so the SAFETY STRAP will
not be visible.
2. Drill a 3/8" hole on the mark.
3. While squeezing the wings together, use your hammer to tap
the WALL ANCHOR from the FURNITURE TIPPING RESTRAINT
KIT (96) into the hole until it is even with the surface of the wall.
4. Fasten the unit to the wall. Use the LONG SCREW through the
hole in the SAFETY STRAP and into the WALL ANCHOR. Turn
multiple turns to completely tighten.
Electric drill
with 3/8" bit
2
Mark and drill
a 3/8" hole
into the wall.
4
WALL ANCHOR
INSTALLATION
96
1
Squeeze the wings
together and tap the
3
WALL ANCHOR into
the 3/8" hole in the wall.
420946
Publicité
