Publicité
Step 22
å
Carefully turn your unit onto its front edges. Unfold the BACK (BK1) and lay it over your unit as shown.
å
IMPORTANT: Your unit must be "squared up" to the BACK (BK1) before fastening. Make equal spacing along all four edges
of the BACK (BK1). Push on opposite corners of your unit if needed to make it "square".
å
BACK INSTALLATION:
1.
Begin fastening the BACK (BK1) using four BLACK 9/16" EURO SCREWS (62S) through the four holes shown at positions 1.
2.
Finish fastening the BACK (BK1) to your unit using the NAILS (1N) through all remaining holes.
3.
NOTE: Be sure to tap NAILS into the holes that line up over the UPRIGHT (P).
NAIL
(44 used in this step)
1
420946
1N
1
www.sauder.com/service
These holes must line up
over the UPRIGHT (P).
BK1
P
8
62S
BLACK 9/16" EURO SCREW
(4 used in this step)
This hole must be to the
right of the UPRIGHT (P).
1
1
Page 27
Publicité
