Publicité
14
a. Maintenance
DAILY
• Follow chapter 5.
MONTHLY
• Check hydraulic oil level (more frequently for high use applications).
GB
• All bearings and shafts are provided with long-life grease at the factory. Long-life grease should be applied to the
lubricationpoints at monthly intervals or after each time the truck is cleaned. Clean off dirt and debris.
EVERY SIX MONTH
• Change oil (more frequently if color has substantially darkened or feels gritty). The required hydraulic fluid type is ISO VG32, its
viscosity should be 30cSt at 40°C, total volume is about 0.3 l.
NOTE:
If hydraulic oil is milky white in color, water is in the hydraulic system. Change the hydraulic oil immediately.
BEFORE STARTING OPERATING THE TRUCK, ENSURE THAT ALL MARKINGS AND DECALS ARE ON THE
RIGHT PLACE AND NOT DAMAGED (ACC. TO FIG. 3). IF NECESSARY REPLACE THE DECALS.
b. Deaeration of the hydraulic system
Air may find its way into the pump during transportation, tilting or usage on uneven ground. It can result in not elevating forks
whilst pumping in the Raise position. The air can be removed in the following way: Move the control handle to the Lower position,
move then the tiller down several times. Thereafter normal operation can be resumed.
c. Adding hydraulic oil to the pump reservoir
• Ensure forks are in lowered position.
• Lay pallet truck on either side. Position drain plug of hydraulic cylinder up.
• Remove the screw plug.
• Add hydraulic oil until level of oil is at bottom of hole.
• Replace drain plug, upright the truck.
0519_Manual PalletTruck1_A5.indd 14
0519_Manual PalletTruck1_A5.indd 14
www.kramp.com
13/06/2023 10:29
13/06/2023 10:29
Publicité
