Publicité
12
a. Parking
Lower the forks to the lowest position and park the Hand
pallet truck on a smooth and even level ground where the
truck not disturbs any other operations. If equipped with
a brake use the brake for parking the truck acc. to the
description further below.
GB
b. Lifting
Check that the load does not exceed the loading capacity of the pallet truck. Roll the pallet truck with its forks slowly under the
pallet/load until the back end of the fork rests against the load (Fig.11). Shift the operating lever down to the Lifting position. Lift
the load by up- and down movements of the tiller arm. The load must be evenly distributed across both forks.
DO NOT OVERLOAD THE TRUCK!
c. Lowering
DO NOT PUT FOOT OR HAND UNDER THE LIFTING MECHANISM!
Lower the load by shift the operating lever up to the lowering position carefully. By releasing the lever, the lowering movement will
stop. Ensure there is adequate clearance behind, then move the pallet truck away.
0519_Manual PalletTruck1_A5.indd 12
0519_Manual PalletTruck1_A5.indd 12
www.kramp.com
Figure 11: Load conditions
13/06/2023 10:29
13/06/2023 10:29
Publicité
