Publicité
10
NOTE:
The marked number on the tiller arm package and the chassis should be the
same. When attaching the handle, you had better squat just in front of the
pallet truck.
GB
a. Insert the tiller arm (1) into the pump piston, then
use a hammer to insert the axle with hole into the
hydraulic pump and tiller arm from the right to the
left (Fig. 6).
b. Set the control lever of the handle to the 'LOWER'
position, then pass the adjusting nut, adjusting bolt
through the hole of the axle with your hand (Fig. 7).
c. Press the tiller arm down; take away the pin (2, Fig.5).
d. Set the control lever of the handle to 'RAISE' position,
then raise the lever plate with the pin (2, Fig. 5) and
insert the adjusting bolt into the front slot of lever
plate. Note: Keep the adjusting nut under the lever
plate.
e. Use a hammer to insert the 2nd dowel pin (5, Fig. 5)
into the 2nd hole of the axle.
b. Hydraulic valve adjustment
On the tiller of your pallet truck, you will find the control lever, which can be
regulated in three positions:
Lower:
handle up, the lever moves back to the neutral, when released
Neutral:
handle in center position
Raise:
handle down
If necessary, you can adjust the lever according to following steps (Fig. 8):
a. If the forks elevate while pumping in the Neutral position, turn the adjusting nut on the adjusting bolt clockwise until pumping
action does not raise the forks and the Neutral position works properly.
b. If the forks descend while pumping in the Neutral position, turn the adjusting nut counter-clockwise until the forks do not
lower.
c. If the forks do not descent when the control handle is in the Lower position, turn the adjusting nut clockwise until raising the
control handle lowers the forks. Then check the Neutral position according to fig. 8 and be sure that the adjusting nut is in the
proper position.
d. If the forks do not elevate while pumping in the Raise position, turn the adjusting nut counter- clockwise until the forks elevate
while pumping in the Raise position. Then check the Lower and Raise position.
0519_Manual PalletTruck1_A5.indd 10
0519_Manual PalletTruck1_A5.indd 10
www.kramp.com
Figure 6: Axle assembling
Figure 7: Side view
Figure 8: Lever
13/06/2023 10:29
13/06/2023 10:29
Publicité
