Cleaning And Care; Removing And Fitting The Appliance Door; Cleaning The Cooking Compartment - Junker+ JB33UC 1 Série Notice D'utilisation

Cleaning and care

:
Risk of short circuit!
Do not use high-pressure cleaners or steam jet cleaners to
clean your appliance.
Caution!
Surface damage due to incorrect cleaning: Do not use any
harsh or abrasive cleaning agents
■
cleaning agents that contain alcohol
■
abrasive cleaning aids such as steel wool or scourers.
■
Observe the specifications in the tables.
Note: Highly recommended cleaning and care products can be
purchased through our after-sales service. Observe the
manufacturer's instructions.
Cleaning the appliance exterior
To ensure that the different surfaces are not damaged by using
the wrong cleaning agent, pay attention to the information in the
table.
Wash new sponge cloths thoroughly before use.
Appliance part/sur- Cleaning agent/aid
face
Stainless steel sur- Apply washing-up liquid with a soft,
faces damp cloth or chamois; dry with a soft
cloth. Use cleaners for brushed stainless
steel finishes if very dirty.
Control panel Hot soapy water:
Clean with a dish cloth and dry with a
soft cloth. Do not use glass cleaners or
glass scrapers.
Door panels Apply glass cleaner or detergent with a
soft, damp cloth or chamois leather; dry
with a soft cloth.
The inner door panel of the appliance
door has a coating which can have the
effect of a light-coloured film.

Cleaning the cooking compartment

Caution!
Risk of damaging the surface. Do not clean the appliance while
still warm, even if using oven cleaners specially intended for
this purpose.
Notes
Due to its technical properties, the enamel may exhibit colour
■
variations. However, this has no effect on the function.
The edges of thin trays may be rough. Anti-corrosion
■
protection is still guaranteed, however.
Appliance part Cleaning agent/aid
Enamel surfaces Apply washing-up liquid or vinegar solution
with a soft, damp cloth or chamois; dry with
a soft cloth. Soften baked-on food residues
with a damp cloth and detergent. Leave the
cooking compartment open to dry after
cleaning.
We recommend using oven cleaner if the
oven is very dirty. Observe the manufac-
turer's instructions when cleaning with an
oven cleaner.
Door seal Hot soapy water
Hook-in racks Hot soapy water:
Soak and clean with a dish cloth or brush.
Appliance part Cleaning agent/aid
Telescopic Hot soapy water:
shelves Clean with a dish cloth or a brush.
Do not remove the lubricant while the pull-
out rails are pulled out – it is best to clean
them when they are pushed in.
Do not soak or clean in the dishwasher.
Accessories Soak in hot soapy water. Clean with a brush
and sponge or wash in the dishwasher.
Keeping the appliance clean
Clean the cooking compartment every time it is used, since dirt
will be burnt on next time the oven heats up and will thus
become hard to remove. Always remove flecks of limescale,
grease, starch and albumin (e.g. egg white) immediately.
Where possible, use the
~
operating mode causes less soiling.

Removing and fitting the appliance door

You can remove the appliance door to clean it more
thoroughly.
:
Risk of injury!
The hinges of the appliance door may snap shut with great
force. Always open the hinge locking lever fully when removing
the appliance door and close it fully after refitting. Do not reach
into the hinge.
:
Risk of injury!
If the appliance door has only been unhinged on one side, do
not reach into the hinge. The hinge can snap back with great
force. Call the after­sales service.
Removing the appliance door
Open the appliance door fully.
1.
Open the locking levers on the left and right-hand side fully.
2.
The hinges are secured and cannot snap closed.
Close the appliance door until resistance becomes
3.
noticeable (figure A).
With both hands, grip the door on the left and right-hand side,
4.
close the door a little more and pull it out (figure B).
2D-Hot air operating mode. This
69