Publicité
6
CRIB ASSEMBLY - MATTRESS SUPPORT PANEL ASSEMBLY
6a. Align the Mattress Support Panel (9) to all the
corners of the crib as shown in the illustration.
6b. Position the Wooden Dowels (D) between the
stabilizer bar and mattress support panel. Use
the Bolt (C) to attach the Mattress Support
Panel to the 4 corners of the crib.
6c. Note that the Lowest position of the
Mattress Support Panel will be for
Toddlers (babies who can stand up
and walk), the Mid position is for
infants (babies who start to turn
and sit up) and the Highest
Position is for newborn babies.
6d. Ensure that the Mattress Support
Panel is flat side up and not at a
slant.
NOTE:
• The Warnings printed on the pouch
attached to the mattress support
panel must face up, and the springs
must face up.
• This crib has adjustment positions.
Use the highest only for newborns,
and move the mattress down as the
child grows.
WARNING:
• Fall Hazard: When a child can stand,
set the mattress at the lowest
position and remove bumper pads,
large toys, and other items that could
serve as steps for climbing out.
22
(C)
9
(D)
(D)
(C)
(C)
9
C
Bolt M6 X 15mm (x4)
Boulon M6 X 15mm (x4)
Perno M6 X 15mm (x4)
(C)
By
Publicité
