Publicité
4.2 Initial use
CAUTION
Ensure that the heat pad will not bunch up or become folded during use.
• To operate the heat pad connect the control to the heat pad by plugging in the connector.
• Then plug in the power plug into the mains outlet.
4.3 Switching on
To switch the heat pad on, set the slider for ON/OFF and temperature settings to setting 1, 2 or 3.
The temperature settings are illuminated when switched on.
4.4 Setting the temperature
Level 0: OFF
Level 1: minimum heat
Level 2: medium heat
Level 3: maximum heat
NOTE:
• The fastest way to warm up the heat pad is to initially set the highest temperature setting.
• This heat pad have a fast heating function, which allows the pad to warm up faster in the first 10 minutes.
WARNING
If the heat pad is being used over several hours, we recommend that you set the lowest temperature setting on the control to avoid
overheating the heated body part, which may lead to burns to the skin.
4.5 Automatic switch-o
This heat pad is equipped with an automatic switch-o function. This turns o the heat supply approx. 90 minutes
after the initial use of the heat pad. The temperature setting display then starts to flash. So that the heat pad can
be switched back on, the slider for ON/OFF and temperature settings (5) must first be set to setting "0" (OFF). After
about 5 seconds it is possible to switch it on again.
4.6 Switching o
To switch the heat pad o , set the slider for ON/OFF and temperature settings to setting "0" (OFF). The temperature settings are
then no longer illuminated.
NOTE:
If the heat pad is not in use, switch the side slider for ON/OFF to setting "0" (OFF) and unplug the power plug from the socket. Then
disconnect the control from the heat pad by unplugging the plug-in coupling.
5. CLEANING AND MAINTENANCE
WARNING
Before cleaning, always remove the power plug from the socket first. Then disconnect the control from the heat pad by unplugging
the plug-in coupling. Otherwise there is a risk of electric shock.
CAUTION
The control must never come into contact with water or other liquids, as this may cause damage.
• To clean the control, use a dry, lint-free cloth. Do not use any chemical or abrasive cleaning agents.
• Small marks on the heat pad can be removed with a damp cloth and if necessary, with a little liquid detergent for delicate
laundry.
CAUTION
Please note that the heat pad may not be chemically cleaned, wrung out, tumble dried, put through a mangle or ironed. Otherwise
the heat pad may be damaged.
• This heat pad is machine-washable.
• Set the washing machine to a particularly gentle wash cycle at 30 °C (wool cycle). Use a delicate laundry detergent and meas-
ure it out according to the manufacturer's instructions.
13
90
min
STOP
Publicité
