Publicité
WARNING:
Strictly adhere to all torque wrench tightening specifica-
tions. Failure to do so could cause serious personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the start key from the tool
when you are assembling parts.
INSTALL THE SEAT
See Figure 1.
Place the seat assembly over the mounting brackets and
align as shown.
Lower the seat clip so it is secured onto the mounting
bracket.
Attach the seat safety interlock cable to the plug on the
mower.
Attach the carabiner clips as shown.
Lower the seat.
INSTALL THE JOYSTICK
See Figure 2.
Insert the joystick through the dust cover as shown.
Align the holes on the joystick to the holes on the mount-
ing shaft.
Insert the hex screws and tighten securely with the in-
cluded hex key.
Align the tabs on the dust cover with the base and press
down to lock the dust cover into place.
ASSEMBLY
CLIP
MOUNTING
BRACKET
JOYSTICK
SHAFT
BOOT
6 — English
SEAT
ASSEMBLY
SAFETY
INTERLOCK
CABLE
BOOT
JOYSTICK
SHAFT
JOYSTICK
MOUNTING
SHAFT
CARABINER
CLIP
PLUG
Fig. 1
HEX
SET SCREW
HEX KEY
Fig. 2
Publicité
