Publicité
6
English
TO REMOVE/REPLACE SHIELD
It is recommended to do one side at a time until you become familiar with
the removal/installation process.
To remove, place shield in the fully open position. Once fully open, black
levers appear from under the shield pivot/holder arms. Slide the levers
forward in the direction of the arrow until the pivot/holder releases from the
base. Once released, lift the pivot/holder off the base.
NOTE:
The shield cannot be removed from any other position as the locking
system will be engaged.
To install, with the shield in its fully open position as it was when removed,
position the pivot/holder over base plate with the bottom and rear edges of
the holder lined up with the base plate edges as shown.
NOTE:
The shield can only be installed from the fully open position
Publicité
Chapitres
