Publicité
OPEN
OPEN
4
CLOSE
OPEN
CLOSE
OPEN
CLOSE
CLOSE
English
TO OPEN/CLOSE SHIELD
Pull outward on lower left side of shield to release latch system and then raise
the shield. To close the shield, push down the shield until the shield is fully
latched
WARNING:
If your shield becomes too scratched or uncleanable, replace it with a
new one. Impaired visibility causes accidents. Use a solution of mild
soap or detergent and lukewarm water to clean your shield. Rinse well
with clean water, and wipe off with a soft cloth. Never use petrol, thinner,
benzene or any other solvents. There are many "aggressive" cleaners
on the market, including some supposed to be specifically for use on
shield. Arai strongly recommends that you do not use any such products
to clean your shield as some of their ingredients may have damaging
effects on the shield and other plastic parts installed on your helmet. Do
not apply stickers or adhesive tape to the shield, as this will weaken the
hard coating. If tinted, the shield is for daylight use only.
TO OPERATE BROWVENTS
The Browvents are operated from fully closed through intermediate, to fully
open positions by simply pulling the vent control down to open, pushing
up to close.
TO OPERATE TOP VENTS
Simply push the switches/levers on each vent to open/close the vents.
Publicité
Chapitres
