Publicité
• MANUAL OPERATION
The pump can be activated manually, for immediate watering.
1. Press the SELECT button to activate programming.
2. The LED blinks on the first row (frequency).
If a frequency is already programmed, simply press the OK button.
Otherwise, select a frequency using the SELECT button, then press the OK button to confirm selection.
NB: frequency selection has no effect on a manual operation, but enables access to point 3
below.
3. The LED blinks on the second row (duration).
Press the SELECT button until you reach the
selection.
Watering starts immediately, for an indefinite time.
!
Don't forget to stop the watering in progress (see chapter MODE OFF, option 2).
• MODE OFF
Option 1
Set frequency LED to "OFF" and confirm.
To reactivate, reprogram the device.
6
/
TECHNICAL SPECIFICATIONS:
THE PUMP:
• Operating voltage: 3 AA NiMH rechargeable
batteries.
• Amperage : ≤ 60 µA
• Operating current : ≤ 320 mA
• Opening type: membrane
WARNINGS
• The KPP24SI kit is intended for private use in the garden, on a terrace or balcony.
• It must not be used for industrial purposes or brought into contact with chemicals, flammable or
explosive materials.
• The pump must be installed vertically.
• Use the pump only with water. The water must be soft and clear, and its temperature must not
exceed 60°C.
• Only use rechargeable batteries. Recharge the batteries beforehand, or leave the pump exposed
to the sun to recharge them. Before a prolonged absence, check the state of the batteries.
• Winter storage: the pump is not frost-resistant. In winter, it should be stored in a dry, frost-free
place. Remove the batteries from the device during winter storage.
The device contains many reusable or recyclable materials. It should not be disposed of in the house-
hold garbage can, but in the special containers provided - 2018/849 Directive (EU).
Device complies with European Directive - N°2014/30/EU.
symbol (manual), then press the OK button to confirm
Option 2
To stop a program in progress or to switch off
manual watering, simply press the SELECT
button.
To reactivate, reprogram the device.
• Temperature range: 1°C to 60°C
• Flow rate: 26L/h, i.e. 0.43L/min (2bars)
THE SOLAR PANEL:
• Operating voltage: 5Volts
• Operating current: 200mA
EN
17
Publicité
