Publicité
TECHNICAL SPECIFICATIONS
Power
Tank capacity
Paraffin
Consumption
Autonomy
Ignition
Weight
Dimensions
PROBLEMS AND SOLUTIONS
Problems
The wick is damp or damaged.
Water mixed with paraffin.
The wick is too high/low or uneven.
The adjustment knob is too tight.
AFTER-SALES SERVICE
_ A damaged switch must be replaced in our after-sales service workshops.
AFTER-SALES SERVICE AND SUPPORT
Our After-Sales Service will answer any questions you may have about repairing and maintaining
your product and about spare parts. Exploded views and information on spare parts can also be
found at: www.eco-repa.com
WARM TECH technical advisors and assistants are available to answer any questions you may
have about our products and their accessories: sav@eco-repa.com
Engage the bit holder using the adjustment knob.
Turn the adjustment knob fully clockwise and raise
the wick.
Do not overtighten.
Cut off any uneven parts of the wick with a pair of
scissors.
Place the wick cover on the burner.
Make sure that the distance between the wick
cover and the wick guide is the same.
Otherwise it will be difficult to move the wick
vertically.
Test the appliance before use.
W
2600
Btu/h
9000
L
4.6
Type
BS2869.C1
L/h
0.25
h
18
Manuel
Kg
4.3
Cm
33x45cm
Allow to dry or replace the wick.
Clean the inside of the tank.
Adjust the height of the wick.
Slightly loosen the knob or replace the gasket.
Solutions
Publicité
