Warmtech WTPAP9000 Traduction Des Instructions D'origine page 19

Switching off :
To switch off the appliance, turn the control knob counter-clockwise until it stops.
watch.
The flame will go out after 3 to 5 minutes.
Turn the knob slightly.
Excessive manipulation of the knob can sometimes cause a jet of flame.
Make sure the flame is completely extinguished before filling the tank or transporting the
appliance.
Make sure the flame is completely extinguished before leaving the appliance unattended.
MAINTENANCE
Be sure to empty the tank before transporting the appliance.
WARNING
Storage :
- Disassemble and clean the appliance before storing. Empty the tank, turn the
Turn the tank upside down and clean with a cloth soaked in paraffin.
- Keep the wick away from the wick holder and the tank.
- Store the appliance in a dry, well-ventilated place.
- Protect it from direct sunlight. If possible, keep it in the dark.
- Do not enclose it in plastic bags, as moisture could form.
- In the event of a fault or for spare parts, contact your dealer.
Maintaining the wick :
After a certain period of use, a tar residue will accumulate on the
of the wick. The fibreglass wick must not be cut. To remove this
residue, burn the wick as follows:
1. Do not fill the tank with paraffin.
2. Light the wick and leave to burn until the flame goes out. By then, the residual
tar will be consumed.
Repeat each time the wick does not soak in enough paraffin.