Publicité
Setting Player to Play Discs via Radio
[Page 20-211
Modulating frequencies selector
This system can change the frequency at
which the FM car radio receives the CD
audio signals within the range of 87.9 to
90.1 MHz in 0.2-MHz increments. (The ini¬
tial setting is 89.1 MHz.) If there is a
strong broadcast station signal near the
current frequency, radio interference may
occur. If it occurs, change the frequency.
Source level adjuster
When you play discs, If the volume is low
compared with that for FM increase the
volume level. If the volume is high and
there is distortion, decrease the volume
level. (The initial setting is "LEVEL-4".)
Pre-emphasis selector
Normally, set the pre-emphasis selector to
"PRE-EMP 1". (The initial setting is "PRE-
EMP 1".)
Play a disc. If you feel the treble is insuffi¬
cient, switch the selector to "PRE-EMP 2"
to boost the treble slightly.
• When the selector is set to "PRE-EMP
2", the sound may distort with some car
radios. In this case, switch it back to
"PRE-EMP 1".
I.Hold down button for more than 2
seconds. The modulator setting
mode will be entered, and the fre¬
quency will be displayed.
If you do nothing within the next 8 sec¬
onds, the modulator setting mode
returns to the normal mode without
changing the most recent settings.
Setting Player to Play Discs via Radio
[Page 20-211
Modulating frequencies selector
This system can change the frequency at
which the FM car radio receives the CD
audio signals within the range of 87.9 to
90.1 MHz in 0.2-MHz increments. (The ini¬
tial setting is 89.1 MHz.) If there is a
strong broadcast station signal near the
current frequency, radio interference may
occur. If it occurs, change the frequency.
Source level adjuster
When you play discs, If the volume is low
compared with that for FM increase the
volume level. If the volume is high and
there is distortion, decrease the volume
level. (The initial setting is "LEVEL-4".)
Pre-emphasis selector
Normally, set the pre-emphasis selector to
"PRE-EMP 1". (The initial setting is "PRE-
EMP 1".)
Play a disc. If you feel the treble is insuffi¬
cient, switch the selector to "PRE-EMP 2"
to boost the treble slightly.
• When the selector is set to "PRE-EMP
2", the sound may distort with some car
radios. In this case, switch it back to
"PRE-EMP 1".
I.Hold down button for more than 2
seconds. The modulator setting
mode will be entered, and the fre¬
quency will be displayed.
MEMO
If you do nothing within the next 8 sec¬
onds, the modulator setting mode
returns to the normal mode without
changing the most recent settings.
Publicité
