Publicité
2.INSTALLATION
2.1 POSITIONING THE AIR
CONDITIONER (P3)
To maintain the best performance from your air
conditioner, prevent breakdowns or hazards,
you must position it correctly. Please follow the
guidelines and instruction below in full, as failure
to do so could cause potential installation
problems.
- The air conditioner must be installed on an
exterior wall that has access to the out side with
a minimum of 2 meters clearance to the outside.
- The air conditioner must be fitted leaving room
all around as illustrated in the paper template.
- The wall on which the air conditioner is installed
must be sturdy and able to withstand the weight
of the air conditioner.
After determining the best place for installation as
described above, please check to ensure that the
wall can be drilled in the chosen area without
interfering with other structures or installations
(beams, piers, pipes, wires, etc.).
Please also ensure that there are no obstacles on
the outside of the wall, which may obstruct air
circulation through the drilled holes, for example:
plants and their leaves, slats or panelling, drain
pipes, overflows and gratings,etc.). Any obstruction
could interfere with the correct performances of the
air conditioner.
Outdoor
2m
P3
Indoor
2m
2.2 PAPER TEMPLATE (P4)
Fasten the template to the wall once the following
guidelines have been thoroughly checked.
-
Do not drill any holes until you are completely
confident that there are no obstacles in the area
you wish to drill and there are no obstructions,
which could be hidden by the construction of the
wall, for example:
Electrical wiring water & gas pipes or supporting
lintels or beams.
-
Ensure that a spirit level is used, as the air
conditioner must be level.
-
Follow the installation instructions in full.
spirit level
8
ENGLISH
P4
Publicité
