Publicité
2.
Install Hardware - Feed coiled end of pull wire through an attachment hole in the
frame and out of the access hole, attach items 1 and 2 and pull the hardware into
place. (3 per side) (See figures 1, 2 and 3) NOTE: Leaving the pull wire attached until
the hitch is raised into place will help prevent pushing the hardware back into the
frame.
3. Raise Hitch - Remove pullwires and loosely install items 3 and 4 onto
carriage bolts (6) places.
Items 3 & 4
©2024 Horizon Global Corporation - Printed in México
3. Raise Hitch - Raise the hitch into place being careful not to push the hardware
into the frame.
4. Tighten all 7/16-14 fasteners to 50 Lb.-ft. (68 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
For additional security, thread locker can be used on all fasteners.
Sheet 5 of 18
76657NP
9-27-24
Rev. A
Publicité
