Publicité
1. Lower Muffler – Using a 15mm socket, remove (2) bolts from exhaust hanger, both sides NOTE: Be sure that exhaust is supported before removing exhaust hangers.
a) Remove the (2) screws from the bottom of the rear fascia using a T15 torxbit.
b) Remove the rubber hanger in front of the muffler. NOTE: Soapy water applied to hanger pins makes removal easier.
c) Lower the exhaust (1) side at a time by pulling on the rear fascia to provide clearance to muffler hangers.
©2024 Horizon Global Corporation- Printed in México
Sheet 4 of 18
76657NP
9-27-24
Rev. A
Publicité
