Publicité
WINE CABINETS
LAY-OVER DECOR PANEL INSTALLATION GUIDE
EN
Door Panel Preparation
Depending on the wine cellar model prepare the overlay panel to the dimensions shown (p.20-
26). Then attach the handle to the overlay panel by using the flat head screws and drive the
screws flush with the panel.
Weight of the overlay panel should not exceed 10 kilograms.
•
It is important to ensure that all drilled holes are drilled to the correct depth (7mm) in order to
•
avoid splits in the wood when hardware is installed.
Drill the handle installation holes in the overlay panel according to the handle you are planning
•
to use.
If reusing the handles came with the unit, drill two holes with holes distance 490mm and
•
diameter 5mm in the overlay panel.
The dimensions of the panel shall not exceed 595 mm in width and shall not increase in height
•
by more than 100 mm at the top and 100 mm at the bottom.
IMPORTANT: Failure to respect the ventilation openings will cause the appliance to overheat,
which could result in serious damage to the product that would NOT be covered by the
manufacturer's warranty.
¡ ATTENTION!
PVMAV / PVMAVP MODELS: When paneling the
wine cabinette door, the front ventilation is lost and
the furniture must be provided with a minimum
rear ventilation of 200cm².
PVMBP / PVMBP-HD MODELS: Leave the front
ventilation of at least 300cm² free.
Please refer to the installation manual for fitting
dimensions.
8
INOXPAN S.L.
Publicité
