Publicité
3.2 Operating your appliance
without a programming base unit
Press the
button repeatedly until COMFORT mode is selected and use the
C=
and HD
buttons to set the desired temperature.
If this setpoint temperature is higher than the room temperature measured by
your appliance, your radiator will start to heat.
d
Radiator heating indicator
Press the button repeatedly until the required operating mode is selected.
3.3 Operating your appliance with a Pilot Wire
programming base unit (not supplied) - Auto mode
The programming base unit sends operating mode commands (No Heat, Frost
Protection, Eco, Comfort) to your radiator via the Pilot Wire in your wiring
system. It can also switch your radiator to one of two supplementary modes
(Comfort -1°C and Comfort -2°C).
First set your required Comfort mode setpoint temperature using the D
and
CY
buttons.
Press the
button repeatedly until AUTO mode is selected.
Then consult the instructions supplied with your Pilot Wire unit for information
on operating your radiator via Pilot Wire.
24
Publicité
