Publicité
Display battery, this function is prepaid in the display PCB, users just need to install a normal 10440
600mAh 3.7V rechargeable lithium battery, then users could power on the display and do setting
without connect to main power.
Display flip, by press up and down button for more than 3 seconds, the display will flip automatically,
this function is useful to read menu conveniently when device is hanged.
o Connecting the mains cable
Earth must always be connected. Power cables must be approved and comply with the IEC
Standard.
Maximum 3 units can be connected in series
Care and maintenance
The outside of the camera should be cleaned regularly. The lenses must be cleaned to ensure
optimum brightness. If the luminaire is installed in a dusty or smoky environment, regular cleaning
is very important. Unplug the device before carrying out any work!
Use a clean, dry cloth.
Risk of electric shock.
Always unplug the appliance before servicing or performing any maintenance.
Here are a few suggestions if you have any problems with your device.
The appliance does not work at all.
o Check the power cord and fuse.
o Make sure that your plug is correctly plugged in.
The fixture does not respond or does not respond correctly to DMX commands.
o Check your DMX cables
o Check your DMX addressing
o Try another DMX controller
o Check that your DMX cables do not run close to high-voltage cables, which could
cause interference.
Does not react to sound
o Check the selected operating mode
o Check that there is no DMX cable connected to DMX IN
o Tap directly on the microphone to test its responsiveness.
LUMINA H200 User's Manual Ver. 1.00
DANGER!
18
Page
Publicité
