Registers And Frame Description; Configuration And Installation; Dismantling The Case; Installation Of The Compression Seal - ADEUNIS PULSE IP68 V4 Guide Utilisateur

LoRaWAN 863-870 PULSE IP68 - Guide utilisateur / User guide V4.0.0
3.

REGISTERS AND FRAME DESCRIPTION

To know the content of the registers and of each frames (uplink and downlink) of the product, refers to
the TECHNICAL REFERENCE MANUAL of the PULSE product, available on the adeunis website:
www.adeunis.com/en/produit/pulse-impulse-interface/
4.

CONFIGURATION AND INSTALLATION

To configure the product, it is recommended to use the IoT Configurator (android and Windows appli-
cation).
- Google Play : https://play.google.com/store/apps/details?id=com.adeunis.IoTConfiguratorApp
- Windows 10: https://www.adeunis.com/telechargements/
To configure the product using AT Command or install the product, please refers to the INSTALLATION
GUIDE adeunis® available on the website.
5. PREPARATION

5.1. Dismantling the case

The product is supplied disassembled such that the lower electronic part can be accessed. This part
is where the meter or meters are connected to the screw terminals and where the micro USB port for
configuration of the device.
Once connection of the meters has been finalized and configuration carried out, the case may be
closed.

5.2. Installation of the compression seal

Before connecting your meter cables to the product's screw terminals, you must insert the compres-
sion gland nut and the appropriate seal for your configuration.
2 types of seals are supplied with the PULSE: for a 5 mm diameter cable and for a 4 mm diameter
cable.

Assembly procedure:

1 - Your meter 2 - Pass the
and its inter- cable through
face. the compres-
sion gland nut.
Seal 1 x 5,4 mm cable
3 - Pass the
cable through
the compression
gland seal
Seal 1 x 4,2 mm cable
4 - Pass the 5 - Connect the
cable through ends of the meter
the case plate. cable to the screw
terminals.
https://
FR
EN
Page 55 of 58