Publicité
MULTI
The Al edit recording enables CD recording without worrying
about tape length and track length. When a CD is inserted, the
unit automatically calculates the total track length. If necessary,
the order of tracks is rearranged so that no track is cut short.
(Al: Artificial Intelligence)
m
Al edit recording will not start from a point halfway into the tape.
The tape must be recorded from the beginning of either side.
7
Insert the tape into deck 2, and press DOLBY NR
to turn Dolby NR on or off.
Insert the tape with the side to be recorded on first facing out
from the unit.
2 Press CD and load the disc(s).
3 Press CD EDIT/CHECK
once.
"EDIT" lights up and "Al" flashes on the display.
4
5
Al EDIT
When "PRGM is displayed, press CD EDIT/CHECK again.
Press one of the DISC DIRECT PLAY 1-5 to select
a disc.
Press +
or W
to designate the tape length.
10 to 99 minutes can be specified.
In a few seconds, the tracks to be recorded on each side of
the tape are determined.
The numbered buttons O-9 or MULTI JOG are also available
to designate the tape length.
Example:
When using a 60-minute tape, press 6 and 0.
Tape length
I
Tape side A
Programmed
(front si~e)
tracks for side A
I
21
ENGLISH
Remaining time
of recording
6 Press @ REC/REC MUTE to start recording.
The tape is rewound to the beginning of the front si~e, the
lead segment is played through for 10 seconds, and recording
starts. When recording on the front (side A) ends, recording
on the back (side B) starts.
To stop recording
Press W. Recording and CD play stop simultaneously.
To clear the edit program
Press
CLEAR twice so that "EDIT" disappears on the display.
To check the order of the programmed
track numbers
Before recording, press CD EDIT/CHECK to select side A or B,
and press U
or FF
repeatedly or turn MULTI JOG.
Program number
Tape sid~ Tr&ck number
Programmed
track numbers
To add tracks from other discs to the edit program
If there is any time remaining on the tape after step 5, you can
add tracks from other discs in the CD compartment .
1 Press CD EDIT/CHECK to select side A or B.
2 Press one of the DISC DIRECT PLAY 1-5 to select a disc.
3 Press the numbered buttons on the remote control to select
tracks.
A track which has a playing time longer than the remaining
time cannot be programmed.
4 Repeat steps 2 and 3 to add more tracks.
Time on cassette tapes and editing time
The actual cassette recording time is usually a little longer than
the specified recording time printed on the label. This unit can
program tracks to use the extra time. When the total recording
time is a little longer than the tape's specified recording time
after editing, the display shows the extra time (without a minus
mark), instead of the time remaining on the tape (with the minus
mark).
Recording is inhibited if the erasure prevention tab on either
side of the tape is broken off.
The Al edit recording function cannot be used with discs
containing 31 tracks or more. "TR OVER" is displayed if this is
attempted.
Publicité
