Publicité
INSERTING TAPES
Deck2
On deck 1, tapes are always played back on both sides.
On deck 2, you can select a reverse mode to play back one or
both sides.
Use Type I (normal), Type II (high/CrOz) or Type IV (metal)
tapes for playback.
Press TAPE/DECK
1/2, then press A PUSH EJECT
to open the cassette holder.
A PUSHEJECT—
Insert a tape with the exposed side down. Push the cassette
holder to close.
To select a reverse mode (deck 2 only)
Each time REV MODE(DECK 2) is pressed, the reverse mode
changes.
To play one side only, select 2,
To play from front side to reverse side once only, select =1.
To play both sides repeatedly, select C=).
When tapes are loaded in both decks, =) on the display
indicates Continuous Play.
—
Insert a tape.
1 Press DOLBY NR to turn Dolby NR on or off to
match the playback tape.
lltl' NR
For tapes recorded with DOLBY NR, turn on DO NR.
For tapes recorded without DOLBY NR, turn off 00 NR.
2 Press+>
to start play.
>:
The front side is being played (forward).
4:
The back side is being played (reverse).
When tapes are loaded in both decks
Press TAPE/DECK 1/2 first to select a deck.
The selected deck number is displayed.
To stop play, press
.
To pause play (deck 2 only), press II.
To resume play, press
again.
To change the playback side, press+>
D(RECTION/PRESET
in play or pause mode.
To fast forward or rewind, press +
or ~
in stop mode.
Then press
to stop the tape.
To start play when the power is off (Direct Play Function)
Press TAPE/DECK 1/2. The power is turned on and play of the
inserted tape begins.
To
set the tape counter to 0000
Press
CLEAR in stop mode.
The counter is also set to 0000 when the cassette holder is
opened.
17
ENGLISH
Publicité
