Publicité
1.
Safety Instructions
Read the entire instruction manual before you start installation and assembly.
Do not begin the installation until you have read and understood the instructions and warnings contained in
this installation sheet.
If you have any questions regarding any of the instructions or warnings, please contact your local
distributor.
This mounting bracket was designed to be installed and utilized only as specified in this manual.
Improper installation of this product may cause damage or serious injury.
This product should only be installed by someone of good mechanical ability, with basic building
experiences and fully understanding of this manual.
Make sure that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
Tighten screws firmly, but do not overtighten.
Overtightening can damage the items, greatly reducing their holding power.
This product is intended for indoor use only.
Using this product outdoors could lead to product failure and personal injury.
2.
Component Checklist – Important
See images.
Ensure that you have received all parts according to the component checklist prior to installing. If any parts
are missing or faulty, contact your local distributor for a replacement.
Mounting hardware not included.
3.
Mounting
See images.
3.1
Wood stud wall mounting
Make sure that the mounting screws are anchored in the centre of the studs.
The use of a stud finder is highly recommended.
Installers are responsible for providing hardware for other types of mounting situations.
The installer must verify that the supporting surface will safely support the combined load of the equipment
and all attached hardware and components.
3.2
Solid brick and concrete mounting
Mark the exact location of mounting holes.
Drill pilot holes.
Screw the wall mount onto the wall.
Slide the L-shaped holder along the wall plate rail until the hole in the holder is aligned with the last hole
but one in the wall plate.
3.3
Installing the VESA plate.
Screw the VESA plate onto the TV.
Tighten all screws but do not overtighten.
3.4
Hanging the TV onto the wall plate
Carefully lift your TV and hook the VESA plate onto the mounted head.
Insert two screws in the mounting holes.
Tighten all screws using the allen key.
4.
Maintenance
Check that the bracket is secure and safe to use at regular intervals (at least every three months).
V. 02 – 25/09/2019
WB063
USER MANUAL
6
©Velleman nv
Publicité
