Publicité
AIRDECK BOAT ASSEMBLY INSTRUCTIONS
1. Clear a flat space (making sure it is clean and free of sharp objects) to unfold your boat. Remove the hull
from its box and take it out of the boat bag. Unroll the hull so it laid out flat.
2. Slightly inflate the boat with the high pressure foot pump. Inflate the three hull chambers to approximately
30% full in order to make floorboard insertion easier. Start to pump up the boat on the tube section with the
overpressure security valve.
Note : Do not use an air compressor. Damage to your boat caused by over inflation from an air compressor is not
covered by your warranty.
3. Assemble the air-deck. Place the deflated air-deck floor in the boat. Make sure the edge of the air-deck floor is tucked
fully between the floor of the boat and under the side tubes.
4. Place the keel valve through the hole of the air-deck floor.
5. Inflate the air-deck floor tightly but no more than 1.00bar pressure.
6. Inflate the keel until the air-deck floor is straightened out well. You may need to step on the air-deck floor to make
it straight.
7. Install the aluminium seat by sliding the flanges on the bottom of the seat onto the rails located on the side floaters.
8. Finish inflating all hull chambers to 100%, or 0.25bar pressure. The boats main tube has a built in overpressure valve for
added security.
9. Inflate the keel to 80% of max pressure. The keel will plane better when it is 80% inflated.
10. Secure the oars by clipping into the oar locks
ALUMINIUM DECK BOAT ASSEMBLY INSTRUCTIONS
1. Clear a flat space (making sure it is clean and free of sharp objects) to unfold your boat. Remove the hull from its box
and take it out of the boat bag. Unroll the hull so it is laid out flat.
2. Slightly inflate the boat with the high pressure foot pump. Inflate the three hull chambers to approximately
30% full in order to make floorboard insertion easier. Start to pump up the boat on the tube section with the
overpressure security valve.
3. Place floor panel 1 into the front (bow) of the boat under the side tubes and ensure the keel valve is located at the centre
of the hole in the board.
4. Next fit panel 2 pushing it tight up against panel 1.
5. Place panel 5 at the rear of the boat and push up against the transom boat.
6. Next fit panel 4 pushing it tight up against panel 5.
7. Finally fit panel 3 up against panel 2. To join panel 3 to panel 4 you will need to lift the join to get the edges to meet and
then push down until flat.
8. To hold the floor rigid fit the side rails along the side of the floor so that they overlap the joins.
9. Install the aluminium seat by sliding the flanges on the bottom of the seat onto the rails located on the side floaters.
10. Finish inflating all hull chambers to 100%, or 0.25bar pressure. The boats main tube has a built in overpressure valve for
added security.
Note : Do not use an air compressor. Damage to your boat caused by over inflation from an air compressor is not
covered by your warranty.
11. Inflate the keel to 80% of max pressure. The keel will plane better when it is 80% inflated.
12. Secure the oars by clipping into the oar locks
4
Publicité
