Frequently Asked Questions - Marmitek MegaView 65 Guide Utilisateur

7 Frequently asked questions

Bad (or no) image and sound
• On the receiver, set another CAT5e/6 network cable length using the cable length
switch [8] (MEGAVIEW 65™).
• Press the reset button [7].
• Check if the A/V device is switched on.
• Use only CAT5e/CAT6 cable as specified in chapter 3 (CAT5e Cable
Requirements).
• Check if the CAT5e/CAT6 cable provides a solid connection (no cable faults).
• Check if the RJ-45 has been connected according to the EIA/TIA T568B standard.
• Please ensure that the maximum cable length is not exceeded.
• Install your system as far away from any RF sources (wireless devices) as
possible.
• Set a low resolution on your HDMI source. The CAT5e/6 cable used probably
cannot deal with the higher resolution bandwidth.
Incorrect 3D display
• Please check whether the HDMI source is set to display 3D and/or it is set to
automatic.
• Both the HDMI source and your HD screen should support the same 3D
formats.
• Please check that 3D is displayed correctly by connecting the HDMI source
directly to the HD display with an HDMI cable.
Do you have any questions that are not answered above?
Please check www.marmitek.com.
MegaView 65/66™ 7