Installation Ir Return (Megaview 66™); Usage - Marmitek MegaView 65 Guide Utilisateur

6.2 Installation IR return (MegaView 66™)
The MegaView 66™ has a built-in "infrared return channel", which allows you to
operate the connected device from another room or through closed cabinet doors using
your own remote control.
1. Connect the IR receiver to the MegaView 66™ receiver [5].
• Position it so that it is visible to your (infrared) remote control, allowing it to receive
the transmitted commands (up to 6 metres).
• The most logical place for the IR receiver is in the vicinity of your display device
(HDTV or projector).
• By using the supplied adhesive strip, placement is possible virtually anywhere.
• Experiment to find the right position before definitive attachment of the IR blaster
LED.
Attention! The adhesive strip may cause discolouration on certain surfaces, or may
leave adhesive residue when removed.
2. Connect the IR extender cable to the MegaView 66™ transmitter [6].
• Stick the IR blaster LED near the HDMI source.
• When positioned correctly, one blaster LED can operate all A/V devices within the
same compartment of a cabinet.
• Experiment to find the right position before definitive attachment of the IR
receiver.
Attention! The adhesive strip may cause discolouration on certain surfaces, or may
leave adhesive residue when removed.
6.3

Usage

1. Switch on the HDMI source (e.g. TV Decoder or Media Centre PC).
2. Switch on the display device (for instance HDTV or projector) and select the
appropriate input. Usually you will do this by pressing the A/V or EXT button of
your remote control.
3. You will receive images from the connected A/V device immediately.
4. The MegaView 66™ can also be used to operate the HDMI source from another
room, by pointing your own remote control at the IR receiver and pressing a
button.
6 © MARMITEK