Publicité
Make sure that the wall is strong enough to
withstand four times the weight of the camera
and the bracket.
For the camera that supports IR, you are required
to pay attention to the following precautions to
prevent IR reflection:
Make sure that there is no reflective surface too
close to the camera lens. The IR light from the
camera may reflect back into the lens causing
reflection.
3.1 Camera Installation
Before you start:
There is a wall mounting bracket included in the
package, and you can purchase a terminal box
separately.
Figure 3-1 Dimension of the Wall Mounting
Bracket
Steps:
1. Loosen and remove the screws to dissemble the
PT joint.
Figure 3-2 Disassemble PT Joint
Note:
①: PT Joint Top; ②: PT Joint Bottom
2. Drill four holes in the wall with a Φ12 mm drill,
and drill four expansion screws into the holes.
Figure 3-3 Drill Expansion Screws into the Holes
3. Align the four holes on the bracket with the four
expansion screws on the wall, install the bracket
on the wall, and tighten the screws.
Figure 3-4 Install Bracket
4. Install the PT joint top to the mounting base of
the camera with four 1/4-20UNC screws, then
connect the safety rope to the hook of the
camera.
Figure 3-5 Install PT Joint Top with Camera
5. Connect the safety rope to the hole. Align the
screw holes on PT joint top with those on PT
joint bottom, and install the camera on the
bracket.
Figure 3-6 Fix Camera to Bracket
6. Loosen the screws to adjust the tilting and
panning angles of the camera, and tighten the
screws after the adjustment. The panning range
is -40° to 40°, and the tilting range is -60° to 60°.
Figure 3-7 Adjust Angle
7. Loosen ③ (the grounding screw), thread the
external ground terminal through the screw,
2
Publicité
