Publicité
EN
1
DESCRIPTION
1.1
PURPOSE
You may use this product for cutting purposes:
•
cutting all types of wood
•
cutting plastic
•
cutting drywall
•
cutting metals
1.2
OVERVIEW
Figure 1.
1 Lock-out button
2 Switch trigger
3 Blade
4 Reciprocating rod
2
GENERAL POWER TOOL
SAFETY WARNINGS
Read all safety warnings, instructions, illustrations
and specifications provided with this power tool.
Failure to follow all instructions listed below may result
in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
3
INSTALLATION
3.1
UNPACK THE MACHINE
Make sure that you correctly assemble the machine
before use.
•
If parts of the machine are damaged, do not use
the machine.
•
If you do not have all the parts, do not operate the
machine.
•
If the parts are damaged or missing, contact the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5 Shoe
6 Shoe release lever
7 Blade release clamp
WARNING
WARNING
WARNING
English
5. Discard the box and package in compliance with
local regulations.
3.2
INSTALL THE BLADE
Figure 3.
Before you install the blade, remove the battery pack
from the machine.
1. Lift the blade release clamp and hold.
2. At the same time, push the blade to the deepest
position.
3. Release the blade release clamp.
Make sure that the blade is tightened. When cutting
wet wood, please clean up the dust and debris near
the blade clamp in time.
3.3
REMOVE THE BLADE
Figure 3.
1. Lift the blade release clamp and hold.
2. At the same time, pull the blade out.
3. Release the blade release clamp.
3.4
INSTALL THE SHOE
Figure 4.
1. Turn the shoe release lever counterclockwise.
2. Push the shoe into the machine.
3. Turn the shoe release lever to original position.
Make sure that the shoe is tightened.
3.5
REMOVE THE SHOE
Figure 4.
1. Turn the shoe release lever counterclockwise.
2. Pull the shoe from the machine.
3. Turn the shoe release lever to original position.
3.6
INSTALL THE BATTERY PACK
Figure 2.
•
If the battery pack or charger is damaged, replace
the battery pack or the charger.
•
Stop the machine and wait until the motor stops
before you install or remove the battery pack.
•
Read, know, and follow the instructions in the
battery and charger manual.
4
NOTE
NOTE
NOTE
WARNING
Publicité
