Publicité
Maintenance
1
Attention! Rotary cutter blade
Before all maintenance and cleaning work:
Pull out the power plug.
Do not touch running blades.
Never spray down the lawnmower using water, especially not
at high pressure.
Regularly check and tighten all visible screws and nuts, espe-
cially those relating to the cutting bar, to ensure a firm fit.
Always have blades changed or re-sharpened by a specialist
workshop, since a balance test must be carried out as speci-
fied in the safety regulations following any removal of parts.
Assembly
Fasten handle bars
A B C D
1
Caution!
The cable can be damaged while folding up or pulling out
the handle bar.
See illustrations.
Inlay the cable in the bend protection
Operation
General
Operating times
Please check noise abatement regulations prevailing in your
country.
Feed cable through the strain relief
Please feed cable through the strain relief
3
Note: WOLF Flick-Flack®
WOLF Flick-Flack® keeps the cable away from the cutting
unit
H
.
Set cut height
J
1
Attention! Rotary cutter blade
Undertake work/adjustments on the equipment only after
the motor is switched off and the cutting tool has come to a
standstill.
Switch off motor and pull out power plug.
1. Press button (1).
2. push chassis downwards or pull upwards, as required.
3. Release button at required cutting height (2).
Selection of Cutting height
If possible, mow when grass is dry in order to protect turf. Do
not se cutting position too low when mowing very hight or wet
grass.
We recommend an average cutting height of 4,0 - 5,0 cm.
Connecting to the mains (230 Volts, A.C., 50 Hz)
The mower operates from any normal household mains supp-
ly, provided with a 16 Amps. fuse.
14
All manuals and user guides at all-guides.com
D
.
G
G
.
Only use original WOLF spare parts. Otherwise we can't gua-
rantee that your mower conforms to the safety regulations.
Never park your lawnmower in damp rooms.
For safety reasons, replace worn or damaged parts.
Disposal
Do not dispose of electrical equipment in domestic
waste. Recycle equipment, accessories and pa-
ckaging in an environment-friendly manner.
Mount the collecting bag
See illustrations.
3
Note: Residual current protection device
These protection devices safeguard while touching
damaged wires, from insulation flaws and in certain cases,
also while damaging live wires.
We recommend that the equipment only be plugged into
a power socket, which is protected by a residual current
protection device (RCD) with a residual current of not
more than 30 mA.
Retrofit kits are available for old installations. Consult an
electrician.
Starting and Stoping
Switch on motor with mowerplaced on level and firm ground.
not in high grass - alternatively tilt slightly
Switch-on motor
L
1. Depress button and hold (1).
2. Lift up bar (2).
3. Release bar (2).
Switch-off motor
L
Release bar (2).
Tips for mowing
To prevent strips of grass from being left unmowed, the cutting
paths must always overlap a few centimeters
Always let cable trail on the cut side of the lawn.
E
F
K
.
M
.
G
Publicité
