Publicité
VT SMART MOP NA - M0S11490 - 2U07_FEV 1000-950.qxd 24/07/2020 12:09 Pagina 12
4.2 Connect the extension tubes to the steam
hose and the floor brush to the extension
tubes.
the cloth on the floor and rest the brush on
top.
4.4 Adjust the intensity of the steam by
turning the adjustment knob; for this type of
surface we recommend
4.5 Deactivate the steam lock and continue
with steam delivery, pressing the steam
trigger on the handle of the steam hose.
4.6 Clean the floors by moving the brush.
The brush has a flexible joint that makes it
possible to easily reach the most difficult-to-
reach areas (under furniture, under beds,
etc.).
floor and scrape off the dirt.
NOTICE
Before removing the cloth from the brush,
wait a few minutes to allow the cloth to cool.
After which, rest a foot on the tab of the
cloth sticking out and pull the brush upward.
WARNING
Do not use the appliance without the cloth.
For additional safety, test steam delivery on
a hidden section of the flooring, leave the
steamed part to dry to ensure that no chan-
ges in colour or deformations have occur-
red.
4.3 Attach the supplied
cloth to the floor brush. To
make it easier to attach, the
cloth
has
an
easy
lock/release
system
avoid having to bend over
and use your hands. Just
place the cleaning side of
Medium level
steam.
The brush has bristles built
into the rear side ideal for
removing
the
most
stubborn
dirt.
To
return the handle to the
vertical position locking the
brush, then tilt until the
bristels are touching the
5. CLEANING CARPETS AND RUGS
WARNING
Before cleaning fabrics with steam, consult the
manufacturer's instructions and always carry
out a test on a hidden section or on a sample of
the material. Allow the steamed section to dry
to
to make sure that no changes in colour or
deformations have occurred.
5.1 Make sure that Chapter 1 has been
followed and connect the accessories as
indicated in Chapter 2.
5.2 Connect the extension tubes to the steam
hose and the floor brush to the extension
tubes.
5.3 Adjust the intensity of the steam by
turning the adjustment knob; for this type of
use,
surface we recommend
steam.
5.4 Deactivate the steam lock and continue
with steam delivery, pressing the steam
trigger on the handle of the steam hose.
5.5 Pass the floor brush over the surface.
NOTICE
Before removing the cloth from the brush,
wait a few minutes to allow the cloth to
cool. After which, remove the frame by
resting the foot on the relative symbol and
then remove the cloth by holding it firm
with the foot resting on the tab and pulling
the brush up.
6. CLEANING GLASS, WINDOWS
AND TILES
WARNING
To clean glass surfaces during cold weather,
preheat the windows starting to vacuum
from a distance of about 1.6 ft (50 cm) from
the surface.
6.1 Make sure that Chapter 1 has been
followed and connect the accessories as
indicated in Chapter 2.
6.2 Adjust the intensity of the steam with the
| 12 |
Insert the brush with the
cloth attached (see point
4.3) in the special carpet-
cleaning frame for sliding
on rugs.
Medium level
of
Publicité
