cecotec BOLERO FLUX DT 608010 GLASS BLACK A++ Manuel D'instructions page 27

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Power icon
2. Booster function icon
3. Increase time/speed icon
4. Display
5. Decrease time/speed icon
6. Delay function icon
7. Light on/off icon
NOTE:
The graphics in this manual are schematic representations and may not exactly match the
device.
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the appliance
out of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the appliance
when transporting it in the future. In case the original packaging is disposed of, make sure
all packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content
- Kitchen hood
- Assembly kit (depending on model)
- Instruction manual
3. INSTALLATION
In figure 2, you can see the dimensions (mm) required for the installation.
The kitchen hood's width is:
- 02847_ Bolero Flux DT 608010 Glass Black A++ > 60 cm
BOLERO FLUX DT 608010 GLASS BLACK A++/WHITE A++
52
BOLERO FLUX DT 908010 GLASS BLACK A++/WHITE A++
- 02848_ Bolero Flux DT 608010 Glass White A++ > 60 cm
- 02929_ Bolero Flux DT 908010 Glass Black A++ > 90 cm
- 02930_ Bolero Flux DT 908010 Glass White A++ > 90 cm
- Before installing the kitchen hood, make sure that the area is clean to prevent it from
sucking in dust or dirt.
- Please note that the kitchen hood must not share the same ventilation duct with other
appliances that use gas or other fuses.
- To facilitate air outlet, the ventilation duct should have a curvature of ≥120° and should be
connected to the outside wall.
- After installation, ensure that the kitchen hood is level to prevent grease build-up on the
end (Fig. 3).
- The kitchen hood should be placed at a distance of 65-75 cm above the cooking surface for
best effect (Fig. 4).
- Figure 5 shows the necessary elements to install the kitchen hood, bracket, and hooks.
Fig. 5 key:
1. Internal chimney bracket
2. External chimney bracket
3. Wall hook
Steps to install the kitchen hood:
1. Install the wall hook in a suitable location once the installation height is set and keep it
aligned. Use screws to fix it to the wall. Fig. 6.
Fig. 6 key:
1. Internal chimney bracket
2. Wall hook
2. Fix the outer bracket on the chimney using two ST4*8 mm screws, and make sure that the
inner part of the chimney can be adjusted to the installation height, as well as that of the
exhaust duct. Then, install the exhaust duct in the chimney of the kitchen hood and place
the hood in the bracket. Fig. 7
Fig. 7 key:
1. Exhaust duct
2. Internal chimney
3. Outer chimney bracket
4. External chimney
NOTE:
- The screws used for the chimney hook are ST4*40 mm self-tapping countersunk head
screws.
- The screws used for the chimney bracket are ST4*40 mm star head screws.
ENGLISH
BOLERO FLUX DT 608010 GLASS BLACK A++/WHITE A++
BOLERO FLUX DT 908010 GLASS BLACK A++/WHITE A++
53