Télécharger Imprimer la page

cecotec BOLERO FLUX DT 608010 GLASS BLACK A++ Manuel D'instructions page 28

Publicité

ENGLISH
3. Place the kitchen hood on the hook on the wall. Fig. 8
4. Use ST4*40 mm star head screws to fix the outer chimney bracket to the wall.
5. Fix the inside of the chimney to the brackets using two screws (ST4*8 mm). Attach the
outside of the chimney to the top of the hood housing using two screws ST4*8 mm. Secure
the housing with safety screws (ST4*40 mm flathead screws). Fig. 9
6. Plug the power cable into the outlet.
Black cable (or brown, depending on models) > phase
Blue cable > neutral
Yellow-Green cable > ground
You must connect the phase and neutral cables to a 220-240 V~/ 50 Hz power cable.
The kitchen hood must be connected to an earthed installation.
Note: there are two safety ventilation ducts in the back housing.
4. OPERATION
When the kitchen hood is switched on, the power icon indicator light is red.
Power icon
-
Press the power icon, the kitchen hood will beep, and all icons will light up, indicating that
the kitchen hood is in standby mode.
-
Press the icon again, the kitchen hood will beep and then switch off.
Booster function icon
-
In standby mode, press the Booster icon, the kitchen hood will beep.
-
The number 4 will appear on the display, indicating that the maximum ventilation (Booster
function) mode has been activated. After 5 minutes, the appliance will automatically go
back to speed 3.
Increase/decrease icons
-
When the appliance is in standby mode, press the increase icon
number 1 will appear on the display, indicating that the hood is operating at low speed.
Press the
icon again, the number 2 will appear on the display, indicating that the hood
is operating at medium speed. If you press the
appear on the display, indicating that the hood is operating at the highest speed.
-
To reduce the extraction power to the medium level, press the decrease icon
number 2 will reappear on the display.
-
Press the
icon again, the number 1 will appear on the display, indicating that the hood
is operating at the lowest speed.
BOLERO FLUX DT 608010 GLASS BLACK A++/WHITE A++
54
BOLERO FLUX DT 908010 GLASS BLACK A++/WHITE A++
, a beep will sound. The
icon a third time, the number 3 will
, the
Delay function icon
-
When the kitchen hood is in operation, press the Delay icon, the hood will beep and the
indicator light will flash, indicating that the kitchen hood has entered the delayed switch-
off mode. The delay time is 5 minutes.
-
After 5 minutes, the kitchen hood will switch off.
Light on/off icon
Press the light bulb icon to switch on the kitchen hood light. Press it again to switch it off.
Gesture control
-
To ensure optimum operation of this function, the hand should be placed close to the
kitchen hood, at a distance of no more than 80 mm.
-
Slide your hand from left to right to operate the kitchen hood at low speed. The hood will
beep and the light icon will light up. Slide your hand again to increase the extraction power
and so on up to the booster speed of the Booster mode.
-
On the other hand, by sliding your hand from right to left, the kitchen hood will go down
from Booster speed to speed 3, and so on until it switches off. The light will stay on, so
swipe left again to switch it off.
NOTE: kitchen hoods are equipped with an overheating protection system that acts to prevent
possible incidents when the motor temperature exceeds the operating limit value.
Automatic opening function
If the hood is operated at low speed (1), the piston is not activated; when the medium speed (2)
is selected, the piston will be activated, and the hood will open by 50 %. If the high speed (3,
Booster) is selected, the piston will be activated again, and the hood will open to 100 %.
Maintenance function
When the kitchen hood is switched on and in standby mode, press and hold the power icon
for about 2 seconds. The indicator light on the power icon will be on and the piston will open
automatically.
Press and hold the icon again for 2 seconds to close the piston and exit the maintenance
function.
In maintenance function, we will not be able to operate the hood using the
increase and decrease).
5. CLEANING AND MAINTENANCE
Always switch off the power supply before cleaning or performing any maintenance work on
the kitchen hood.
ENGLISH
icons (speed
BOLERO FLUX DT 608010 GLASS BLACK A++/WHITE A++
BOLERO FLUX DT 908010 GLASS BLACK A++/WHITE A++
55

Publicité

loading

Ce manuel est également adapté pour:

Bolero flux dt 608010 glass white a++Bolero flux dt 908010 glass black a++Bolero flux dt 908010 glass white a++